2021 IFGC : International Fuel Gas Code. International Code Council ; American Gas Association. txt
Idioma: Inglés Series The International Codes. 2020 Country Club Hills, IL : International Code Council, 2020Edición: August 17, 2020Descripción: xii, 196 p. charts ; ill. 28 cmTipo de contenido:- text
- unmediaded
- volume
- 1609839668
- 9781609839666
- 9781609839673
- International Fuel Gas Code 2021
- 2021 International Fuel Gas Code
- International Codes 2021
- 23 343.0786962
- KF5704 I58 2020
| Imagen de cubierta | Tipo de ítem | Biblioteca actual | Biblioteca de origen | Colección | Ubicación en estantería | Signatura topográfica | Materiales especificados | Info Vol | URL | Copia número | Estado | Notas | Fecha de vencimiento | Código de barras | Reserva de ítems | Prioridad de la cola de reserva de ejemplar | Reservas para cursos | |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Libro Referencia CARIBET | CARIBET Biblioteca Arquitectura Colección de Referencia CARIBET | Referencia KF5704 I58 2020 (Navegar estantería(Abre debajo)) | 1 | Disponible | 91000000064030 |
Descripciones mejoradas de Syndetics:
Addresses the design and installation of fuel gas systems and gas fired appliances through prescriptive and performance requirements. Key changes in the 2021 IFGC include: The termination of concealed condensate piping requires marking to indicate if it is the primary drain or the secondary drain. Press-connect joints are acceptable for high pressure (over 5 psi) applications indoors. Commercial cooking appliances are not allowed within dwelling units.
Includes index.
CHAPTER 1 SCOPE AND ADMINISTRATION --
PART 1—SCOPE AND APPLICATION--
101 Scope and General Requirements (IFGC) --
102 Applicability (IFGC) --
PART 2—ADMINISTRATION AND ENFORCEMENT --
103 Code Compliance Agency (IFGC) --
104 Duties and Powers of the Code Official (IFGC) --
105 Approval (IFGC) --
106 Permits (IFGC) --
107 Construction Documents (IFGC) --
108 Notice of Approval (IFGC) --
109 Fees (IFGC) --
110 Service Utilities (IFGC) --
111 Temporary Equipment, Systems and Uses (IFGC) --
112 Inspections and Testing (IFGC) --
113 Means of Appeal (IFGC) --
114 Board of Appeals (IFGC) --
115 Violations (IFGC) --
116 Stop Work Order (IFGC) --
CHAPTER 2 DEFINITIONS --
201 General (IFGC) --
202 General Definitions (IFGC) --
CHAPTER 3 GENERAL REGULATIONS --
301 General (IFGC) --
302 Structural Safety (IFGC) --
303 Appliance Location (IFGC) --
304 Combustion, Ventilation and Dilution Air (IFGS) --
305 Installation (IFGC) --
306 Access and Service Space (IFGC) --
307 Condensate Disposal (IFGC) --
308 Clearance Reduction (IFGS) --
309 Electrical (IFGC) --
310 Electrical Bonding (IFGS) --
CHAPTER 4 GAS PIPING INSTALLATIONS --
401 General (IFGC) --
402 Pipe Sizing (IFGS) --
403 Piping Materials (IFGS) --
404 Piping System Installation (IFGC) --
405 Piping Bends and Changes in Direction (IFGS) --
406 Inspection, Testing and Purging (IFGS) --
407 Piping Support (IFGC) --
408 Drips and Sloped Piping (IFGC) --
409 Shutoff Valves (IFGC) --
410 Flow Controls (IFGC) --
411 Appliance and Manufactured Home Connections (IFGC) --
412 Liquefied Petroleum Gas Motor Vehicle Fuel-dispensing Facilities (IFGC) --
413 Compressed Natural Gas Motor Vehicle Fuel-dispensing Facilities (IFGC) --
414 Supplemental and Standby Gas Supply (IFGC) --
415 Piping Support Intervals (IFGS) --
416 Overpressure Protection Devices (IFGS) --
CHAPTER 5 CHIMNEYS AND VENTS --
501 General (IFGC) --
502 Vents (IFGC) --
503 Venting of Appliances (IFGS) --
504 Sizing of Category I Appliance Venting Systems (IFGS) --
505 Direct-vent, Integral Vent, Mechanical Vent and Ventilation/Exhaust Hood Venting (IFGC) --
506 Factory-built Chimneys (IFGC) --
CHAPTER 6 SPECIFIC APPLIANCES --
601 General (IFGC) --
602 Decorative Appliances for Installation in Fireplaces (IFGC) --
603 Log Lighters (IFGC) --
604 Vented Gas Fireplaces (Decorative Appliances) (IFGC) --
605 Vented Gas Fireplace Heaters (IFGC) --
606 Incinerators and Crematories (IFGC) --
607 Commercial-industrial Incinerators (IFGC) --
608 Vented Wall Furnaces (IFGC) --
609 Floor Furnaces (IFGC) --
610 Duct Furnaces (IFGC) --
611 Nonrecirculating Direct-fired Industrial Air Heaters (IFGC) --
612 Recirculating Direct-fired Industrial Air Heaters (IFGC) --
613 Clothes Dryers (IFGC) --
614 Clothes Dryer Exhaust (IFGC) --
615 Sauna Heaters (IFGC) --
616 Engine and Gas Turbine-powered Equipment (IFGC) --
617 Pool and Spa Heaters (IFGC) --
618 Forced-air Warm-air Furnaces (IFGC) --
619 Conversion Burners (IFGC) --
620 Unit Heaters (IFGC) --
621 Unvented Room Heaters (IFGC) --
622 Vented Room Heaters (IFGC) --
623 Cooking Appliances (IFGC) --
624 Water Heaters (IFGC) --
625 Refrigerators (IFGC) --
626 Gas-fired Toilets (IFGC) --
627 Air-conditioning Appliances (IFGC) --
628 Illuminating Appliances (IFGC) --
629 Small Ceramic Kilns (IFGC) --
630 Infrared Radiant Heaters (IFGC) --
631 Boilers (IFGC) --
632 Equipment Installed in Existing Unlisted Boilers (IFGC) --
633 Stationary Fuel-cell Power Systems (IFGC) --
634 Gaseous Hydrogen Systems (IFGC)
635 Outdoor Decorative Appliances (IFGC)
CHAPTER 7 GASEOUS HYDROGEN SYSTEMS --
701 General (IFGC) --
702 General Definitions (IFGC) --
703 General Requirements (IFGC) --
704 Piping, Use and Handling (IFGC) --
705 Testing of Hydrogen Piping Systems (IFGC) --
706 Location of Gaseous Hydrogen Systems (IFGC) --
707 Operation and Maintenance of Gaseous Hydrogen Systems (IFGC) --
708 Design of Liquefied Hydrogen Systems Associated with Hydrogen Vaporization Operations (IFGC) --
CHAPTER 8 REFERENCED STANDARDS --
APPENDIX A SIZING AND CAPACITIES OF GAS PIPING (IFGS) --
A101 General Piping Considerations --
A102 Description of Tables --
A103 Use of Capacity Tables --
A104 Use of Sizing Equations --
A105 Pipe and Tube Diameters --
A106 Examples of Piping System Design and Sizing --
APPENDIX B SIZING OF VENTING SYSTEMS SERVING APPLIANCES EQUIPPED WITH DRAFT HOODS, CATEGORY I APPLIANCES AND APPLIANCES LISTED FOR USE WITH TYPE B VENTS (IFGS) --
B101 Examples Using Single-appliance Venting Tables --
B102 Examples Using Common Venting Tables --
APPENDIX C EXIT TERMINALS OF MECHANICAL DRAFT AND DIRECT-VENT VENTING SYSTEMS (IFGS) --
C101 General --
APPENDIX D RECOMMENDED PROCEDURE FOR SAFETY INSPECTION OF AN EXISTING APPLIANCE INSTALLATION (IFGS) --
D101 General --
D102 Occupant and Inspector Safety --
D103 Gas Piping and Connections Inspections --
D104 Inspections to be Performed with the Appliance not Operating --
D105 Inspections to be Performed with the Appliance Operating --
D106 Appliance-specific Inspections --
APPENDIX E BOARD OF APPEALS --
101 General --
INDEX.